NAME
sdaoe – ATA–over–Ethernet (AoE) storage device interface

SYNOPSIS
bind –a #S /dev
echo config switch on spec
l type aoe//dev/aoe/shelf.slot >/dev/sdctl
echo config switch off spec
l >/dev/sdctl
/dev/sd
l0/ctl
/dev/sd
l0/raw
/dev/sd
l0/data
...
addaoe letter unit

DESCRIPTION
Sdaoe has a few quirks because network–attached storage can't be enumerated as directly–attached storage can. The default first controller letter for AoE devices is e. Each sdaoe device must be configured explicitly.

Addaoe packages up the switch on invocation as an rc script.

To boot from an AoE root, the sd device must be configured on boot by either PXE booting or booting from directly–attached storage and adding two configuration lines to plan9.ini(8) for aoeif, listing the names of the Ethernet interface(s) to use, and aoedev=letter!#æ/aoe/lun.

EXAMPLES
To configure target (LUN) 42.0 on #S/sde0,
echo config switch on spec e type aoe//dev/aoe/42.0 >/dev/sdctl

To turn this device off,
echo config switch off spec e >/dev/sdctl

To boot using target 42.0 as #S/sde0 and as root, over Ethernet interfaces 0 and 1,
aoeif=ether0 ether1
aoedev=e!#æ/aoe/42.0

SOURCE
/sys/src/9/port/sdaoe.c

SEE ALSO
aoe(3), sd(3), snoopy(8)

BUGS
It is not currently possible to boot from an AoE target without an external bootstrap like PXE.
Copyright © 2024 Alcatel-Lucent. All rights reserved.