Semiconductor Yield Modeling
Monday 2 June, 2:40--4:30

Organizer: Mark HANSEN
Bell Labs
Moderator: Mark HANSEN
Bell Labs

Mechanistic Yield Model for MOS IC Chips

Charles M. DRUM
Lucent Technologies, Allentown, PA, USA
As a supplement to statistical yield models, the mechanistic yield model for IC chips is based on random yield-loss mechanisms. These include lateral shorts between runners in the various conductor levels, interlevel shorts between the conductors on different levels, open circuits in the various conductor runners, and open circuits at the various window configurations. Each mechanism is characterized two other quantities. These are the critical area per mechanism, which is design specific; and the defect density per mechanism, which is design independent. The full model combines the contributions of random yield with those of non-random yield. This model is largely empirical since the critical areas per mechanism are deduced from the particular IC design, and the defect densities per mechanism are measured with test structures.

The results are used to rank order the effects of particular random yield-loss mechanisms, and to determine the contributions of design and of processing. Some examples will be discussed, including various ICs (memory, ASICs, processors, mixed-signal) and various processes including deep sub-micron MOS.

[Charles M. Drum, Lucent Technologies, 555 Union Boulevard, Allentown, PA 18103 , cdrum@lucent.com]


Modeling the Yield Impact of Parametric and Other Large-Area Defects

C. Neil BERGLUND
Oregon Graduate Institute of Science and Technology, Portland, OR, USA
In a recent publication it has been shown that large-area yield loss contributors such as those caused by poor parametric control can be modeled through a straightforward extension of the Murphy yield integral1. Of particular importance in this work is the conclusion that such large-area defects result in a die-size-dependent reduction in yield that is similar to that caused by small-defect clustering. In this paper the model is extended both to help distinguish between such large-defect problems and small-defect clustering, and to relate yield loss to parametric control parameters such as the capability indexes Cp and Cpk as well as to the often-observed yield drop near the edges of wafers. Experimental data is compared to the predictions of the model.

1. C. Neil Berglund, "A Unified Yield Model Incorporating Both Defect and Parametric Effects," IEEE Trans. Semiconduct. Manufact., vol. 9, no. 3, pp. 447-454, 1996.

[C. Neil Berglund, Oregon Graduate Institute of Science and Technology, PO Box 91000, Portland, OR, 97291-1000, USA, berglund@eeap.ogi.edu]


Back to JRC program
Back to JRC Home Page